In cold weather, many houses show the same signs: water on the glass, black spotting in a bedroom corner, or paint that will not stay put.
It is tempting to hack the plaster off and start again. New plaster does not fix a moisture problem, though. If the cause is still there, the fresh wall can stain, blow or grow mould again. Work out where the water is coming from first.
Birmingham has a mix of older terraces, inter-war semis and newer flats, so homes differ in age and construction. In any of them, check where the moisture is coming from before replacing plaster.
The foil test
Tape a square of kitchen foil tightly to the affected wall, so air cannot sneak in around the edges, and leave it for a day or two. If moisture forms on the room side of the foil, the water is coming from the air in the room: that is condensation. If it forms underneath, against the wall, the moisture is coming through the wall itself, which points to penetrating damp or a leak.
Black mould on cold corners
Black mould in corners, behind wardrobes, around window reveals or on a cold ceiling is usually condensation. Warm, moist air from cooking, showers, drying clothes and everyday living hits a cold surface and turns back into water. It is worse in winter and in poorly ventilated rooms, and the marks are often spread out rather than in one sharp patch.
Try the simple fixes first. Keep the heating steady so walls and corners are not left stone cold. Use extractor fans that vent outside, and leave trickle vents open. Wipe the inside of windows on cold mornings, rather than letting the water run down the plaster. Pull furniture and wardrobes a little way off outside walls so air can move behind them. If the mould eases once the room is warmer and better ventilated, the plaster itself may be fine.
Signs the plaster has failed
Sometimes the plaster itself has failed. Look for blown areas that sound hollow when tapped, or have come away from the wall; plaster that crumbles in the hand; and salty white deposits, known as efflorescence, on the surface or in the paint.
A defined wet patch that gets worse after heavy rain is more likely to be water getting in from outside, often below a gutter, around a window or behind cracked render. Check the same spot outside. A fairly level tide mark near the floor can be rising damp, which is less common than many people think. If water has been coming through the wall, repair the outside problem first and give the wall time to dry. Salt-contaminated plaster usually has to come off, because the salts can keep drawing moisture from the air even after the source has been stopped.
When to get a wall checked
A plasterer or a damp survey is not needed for every black corner in winter. If the windows run with water, the mould is in cold corners, and better ventilation, steadier heating and wiping the glass have not yet been tried, start there.
A wall should be looked at if a patch keeps coming back after rain, the plaster is blown, crumbly or salty, there is a tide mark along the skirting, or the simple measures have not helped. Find the cause and let the wall dry before any re-plastering.
The author is a director of RCR Connections Ltd, plasterers and renderers based in Birmingham.



